JMC JIMMY 1993 Owner's Manual page 302

Service & Appearance Care
Hood Latches and Hood Hinge
Refer to the Maintenance Schedule to determine how to lubricate the hood
latch and hood hinge assembly.
Propeller Shaft Slip SplinedUniversal Joints
Refer to the Maintenance Schedule to determine how often the slip and
universal joints must be lubricated and what type of lubricant to use.
Body
Normal use
of
your vehicle will cause metal to metal wear at some points
on
the cab and body i f they are not lubricated.
For exposed surfaces, Such as door checks, door lock bolts, lock striker
plates, dovetail bumper wedges, etc., a thin film of engine oil should be
applied.
Where oil holes are provided
in the body or cab, a dripless
oil can be used.
The seat adjusters and seat track should be lubricated with chassis grease.
Door weather strips and rubber hood bumpers should be wiped clean with a
wet cloth and lightly coated with a rubber lubricant.
Never use too much of any lubricant and be sure to wipe up any extra
lubricant when you are finished.
Window regulators and controls are inside the doors. They are lubricated with
a long lasting grease. If lubrication is required your dealer should perform this
service.
Refer to the Maintenance Schedule to determine how often to lubricate these
items and what type of lubricant to use.
Lock Cylinders
To be sure your locks operate properly, they must be lubricated.
Refer to the Maintenance Schedule to determine how often to lubricate them
and what type of lubricant
to
use.
You should not use penetrating oils because they could wash out the factory
',
installed lubricant and cause the lock to bind. De-icers which contain alcohol
could also wash away the lubricant, so be sure to lubricate the lock after
using a deicer of this type.
Tailgate Handle
The tailgate handle pivot points on your vehicle should be lubricated to keep
the handle working smoothly.
Refer to the Maintenance Schedule to determine how often to lubricate them
and what type
of lubricant
to use.
6-36