JMC JIMMY 1993 Owner's Manual page 284

Service & Appearance Care
PO165
3. Check both sides of the dipstick, and read the lower level. The fluid
level must be in the COLD area for
a cold check or in the
HOT area or
cross-hatched area for a hot check.
way. Flip the handle down to lock
it in place.
4. I f
the fluid level is where
it
should be, push the dipstick back in all the
,
How To Add Fluid:
Refer to the Maintenance Schedule to determine what kind of transmission
.
fluid to use. See "Recommended Fluids and Lubricants"
in
the Index.
If the fluid level is low, add only enough of the proper fluid to bring the level
up to the COLD area for
a
cold check or the HOT area for a hot check. It
doesn't take much fluid, generally less than a pint. Don't overfill. We
recommend you use only
fluid labeled DEXRON@IIE, because fluids with that
label are made especially for your automatic transmission. Damage caused by
fluid other than DEXRON@IIE is not covered by your new vehicle warranty.
After adding fluid, recheck the fluid level as described under "How To
When the correct fluid level is obtained, push the dipstick back in all the
Check".
way, then flip the handle down to lock the dipstick in place.
6-1 8