Connecting To A Mobile Phone; Accepting A Call - Navigon 7110 User Manual

User's manual NAVIGON 7100 | 7110
6. Tap on
The B
established between the two devices. At the bottom edge of the
screen, the name of the connected mobile phone is displayed.
Note: With some mobile phones you must first enter a password on the
NAVIGON 7100 | 7110. Then enter the same password on the mobile
phone.
12.3.2

Connecting to a mobile phone

The word connect describes any subsequent connections between
paired Bluetooth devices. No further password entry is necessary when
connecting.
Note: If the battery of the NAVIGON 7100 | 7110 was empty, all data
about previous pairings with mobile phones will have been deleted. You
must then pair your mobile phone again. (See "Pairing with a mobile
phone", page 49)
Connections must be initiated using NAVIGON 7100 | 7110.
Note: Some mobile phones connect automatically to the
NAVIGON 7100 | 7110 without you needing to initiate this connection.
1. Ensure that Bluetooth is activated on the mobile phone.
2. In the B
(Connect).
Note: Some mobile phones require the connection to be initiated from
the mobile phone. Please consult the mobile phone's manual if you are
uncertain about how to carry out the necessary steps on the mobile
phone.
A connection is established between the two devices. The name of the
connected mobile phone is displayed at the bottom edge of the
B
LUETOOTH
12.4

Accepting a call

When you receive a call, the I
corresponding information is available, it will display the callers number.
- 50 -
> OK.
HF P
LUETOOTH HONE
HF P
LUETOOTH HONE
HF P window.
HONE
window opens. A connection is
window, tap on
C window opens. If the
NCOMING ALL
Handsfree Module