Nautilus BE STRONG NS 75X Assembly Manual page 14

STEP 6
37 3/8" x 1"L
25
44
43
40
Step 6 Components:
# component
25 Leg Press Cable w/ Termination 1
26 3 1/2" Pulley
27 4 1/2" Pulley
34 Hex Bolt - 3/8" x 2 3/4"L
35 Hex Bolt - 3/8" x 2"L
37 Hex Bolt - 3/8" x 1"L
40 3/8" Flat Washer
43 3/8" Lock Nut
44 Step Spacer
1
43
35
3/8" x 2"L
6
3/8" x 2 3/4"L
34
26
34
27
35
3/8" x 2"L
25
Procedure:
a. Attach the looped end of the Leg Press Cable (25) to the cable bracket
Qty
4
B. Place two 3 1/2" Pulleys in the Seat Back Support Assembly using the
3
4
3
c. Run the cable over the 3 1/2" Pulleys and attach them to the Seat
1
6
D. Attach a 4 1/2" Pulley to the Leg Press Power Arm using the hardware
8
8
e. Wrap the cable around a 4 1/2" Pulley and secure in place using the
F. Connect the Leg Press Cable Termination to the Gym Cable.
G. Adjust the cable tension using the adjustments located on the gym.
H. Attach leg press handles as shown in Step #2.
ASSEmBLY
26
34
34 3/8" x 2 3/4"L
35 3/8" x 2"L
located on the Seat Back Support Assembly using the hardware
shown above.
hardware shown above. Pass the Leg Press Cable over the pulleys
and slide the cable through the Seat Tube Assembly out the front.
Tube Assembly using the hardware shown.
shown above. Pass the cable over the top of the pulley and then over
the top of the lower 3 1/2" pulley in step C.
hardware shown and the L Cable Retainer (6) to the Angled Pulley
Bracket (7).
NOT USED ON THE
NS700X
27