Figure 2-5. Listen Address Setting For Listen Address 10 Hex - National Instruments GPIB-COM User Manual

Configuration and Installation
Figure 2-5 shows the switch configuration needed when using a device with listen address 10 hex.
The listen address varies with each device so check the listen address of your device and set these
five bits accordingly.
Key
This side down for logic 1

Figure 2-5. Listen Address Setting for Listen Address 10 Hex

GPIB-COM User Manual
= side you must press down for Listen Address 10;
Off = 1; On = 0
= used for setting REN* ON, IFC* ON, and SRQ* ON
This side down for logic 0
U13
1
2
4
8
16
REN
IFC
SRQ
2-6 © National Instruments Corporation
Section Two