Installation; Figure 2-6. Switch Setting For Ren* On, Ifc* Off, And Srq* Off - National Instruments GPIB-COM User Manual

Section Two
Figure 2-6 shows the switch configuration for REN* asserted, IFC* disabled, and SRQ* disabled.
Key
This side down for logic 1

Figure 2-6. Switch Setting for REN* ON, IFC* OFF, and SRQ* OFF

Installation

Once you have changed, verified, and recorded the switches and jumper settings, you are ready to
install the GPIB-COM.
The following steps are general installation instructions. Consult the user manual or technical
reference manual of your personal computer for specific instructions and warnings.
1. Turn off your computer.
2. Remove the plug from its power source.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of your computer.
5. Insert the GPIB-COM in an unused full-length slot with the IEEE-488 receptacle sticking out
of the opening of the back panel. It may be a tight fit, but do not force the board into place.
6. Screw the right angle mounting bracket of the GPIB-COM to the back panel rail of your
computer.
© National Instruments Corporation
= side you must press down for REN* ON, IFC* OFF, and
SRQ* OFF; Off = 1; On = 0.
= used for setting Listen Address
U13
2-7
Configuration and Installation
This side down for logic 0
1
2
4
8
16
REN
IFC
SRQ
GPIB-COM User Manual