Stopping a printing operation halfway
Perform the following operation when stopping a printing operation halfway.
1
Press the
• The printing operation stops.
• Interrupt data sending at the PC side during the data is sent from the
PC.
• Printing restarts from the interrupted data by repressing the
• When printing operation stops, the UV
• It takes 30 seconds to light up the UV
Deleting Received Data (Data Clear)
When you want to stop printing, delete the already received data.
1
Press the
2
Press the
• The ACTIVE lamp goes out.
• The received data is erased then it returns to the local mode.
Behavior after printing has been completed
Drying Feed
When printing has been completed, the feeding operation is performed to cure the printed surface with the UV
lamp.
• Perform the feeding operation until the back edge of printing passes the UV lamp unit.
• When you press the
• When the machine has been received next data continuously, it will operate after the last data is received.
Screen display during drying feeding
• When the media remains less, the printed surface cannot be cured enough. Therefore, be careful
about the remaining amount of media.
key during printing.
lamp is OFF.
lamp.
key in LOCAL.
key.
key, the operation is terminated.
D r y i n g
P l e a s e Wa i t
Printing Data
< L OCA L >
w i d t h : 1 2 7 2 mm
key.
DA T A C L E AR
[ EN T ]
* * DA T A C L E AR * *
2-25
1
2
4
5
6