Table of Contents
Advertisement
Test Feeding
Since heater is used at high temperature, cockles may occur in some of your media. (
Perform this function before printing, and check whether the media can be fed normally.
1
Press the
times.
2
Press the
3
Press
4
Press the
5
Press
6
Press the
7
Press the
• Start test feeding.
8
Press the
• The feeding operation is continued until you press the
• Feed it to some extent and check the feeding status, and then press the
2-16
key in LOCAL three
key.
to select ON/OFF.
• When setting "ON", rewind the roll media
to take up the slack before printing.
key.
to select OFF.
• When "Manual Drying Feed" is operated,
select "ON". (
P.2-26)
key.
key.
• For "manual Drying Feed", when you open
the shading cover while the UV lamp lights,
the UV lamp is turned off. However, the
operation will continue.
key.
P.5-11)
T E S T F E ED
B ACKWARD F E ED
: ON
B ACKWARD F E ED
: ON
UV L AMP
: ON
UV L AMP
: OF F
T E S T F E ED
S T AR T
* * T E S T F EED * *
P L E A SE : WA I T
key.
key to terminate.
[ EN T ]
[ EN T ]
Advertisement
Table of Contents
