Before You Start - Ryobi RAP200 User Manual

GB
FR DE ES
ELECTRICAL
Check with a qualified electrician or service personnel if
the grounding instructions are not completely understood,
or if in doubt as to whether the product is properly
grounded.
Repair or replace a damaged or worn cord immediately.
This product is for use on a nominal 230 V circuit and has
a grounding plug similar to the plug. Only connect the
product to an outlet having the same configuration as the
plug. Do not use an adapter with this product.

BEFORE YOU START

„ The RAP200 paint station is compatible with the
following paints:
- phenol aldehyde paint series
- nitryl paint series
- alkyd paint series
- epoxy resin paint series
- oxidized rubber paint series
- latex paint series
- water soluble paint series
„ Before each use, check all hoses for cuts, leaks,
abrasion or bulging of cover. Check for damage or
movement of couplings. Immediately replace the hose
if any of these conditions exist. Never repair a paint
hose. Replace it with another grounded high pressure
hose.
ASSEMBLY
TOOLS NEEDED
Adjustable wrench (2), 2 mm hex key
INSTALLING THE WHEELS
See Figure 3.
To attach the wheels to the base:
„ Locate the axle assembly.
„ Slip the axle into the wheel hole. Slide small washer
onto axle.
„ Lifting the paint station slightly, slide the axle, wheel,
and small washer into the wheel mounting hole in the
machine base.
„ Slide large washer onto the axle.
„ Push the hitch pin into the hole on the end of the axle
to secure assembly.
„ Repeat with the second wheel assembly.
IT NL PT DK SE FI NO RU PL CZ
English
FOLDING THE HANDLE
See Figure 4.
„ To raise the handle: pull the handle up until the
handle release knob snaps through the locking hole
to secure the handle in place.
„ To lower the handle (for storing): pull the handle
release knob on the right side of handle and lower.
CONNECTING HIGH PRESSURE HOSE/PISTOL-GRIP
SPRAYER
See Figure 5.
To connect the high pressure hose to the paint
station:
„ Screw the collar on the high pressure hose onto the
spray hose outlet located on the pump.
„ Tighten securely with an adjustable wrench.
To connect the pistol-grip sprayer to the high
pressure hose:
„ Screw the collar on the high pressure hose onto
the pistol-grip sprayer by turning the hose collar
clockwise.
„ Use an adjustable wrench to hold the nut on the
pistol-grip sprayer and another to turn and tighten the
nut on hose end and tighten securely.
INSTALLING REVERSABLE SPRAY TIP AND NOZZLE
TIP GUARD ON PISTOL-GRIP SPRAYER
See Figure 6.
See operator's instructions for flushing, priming and
cleaning before installing nozzle tip guard and spray tip.
Note all warnings regarding use of pistol-grip sprayer and
the possibility of injection.
„ Turn lock-off thumbscrew counterclockwise to lock
sprayer trigger.
„ Install nozzle seat and cap into nozzle tip guard.
„ Thread nozzle tip guard assembly onto sprayer and
tighten securely.
„ Select spray tip and push securely into nozzle tip
guard.
„ Keep pistol-grip sprayer trigger locked when not in
use.
INSTALLING PAINT ROLLER
See Figure 7.
„ Place roller caps in each end of the paint roller.
„ Align pins in the end of each roller cap to the holes
inside the roller head. Push out on the side of the
roller head until the roller snaps into place.
4
HU RO LV LT EE HR SI SK GR TR