Installation Of Pitch Frame (Bag D) - THUNDER TIGER Raptor 90 3D Assembly And Maintenance Manual

1-5
Installation of Pitch Frame
No. Material No. Description
1 HMC2-6B Socket Screw M2x6
2 HMC3-10B Socket Screw M3x10
3 HMC3-25B Socket Screw M3x25
4 HME3-3B Set Screw M3x3
5 HMJ3-20N Self-Tapping Screw M3x20
6 HMS4 E Ring
7 HMY2-10 Pin 2x10
8 BK0086 Ball link 4.8x20
9 BK0088 Washer d3xD5x0.5
Please complete subassemblies 1-5-1 through 1-5-5 first, then add them to the Main Frame. Fit the Pitch Control Frame
Subassembly. Attach the E Ring on the left side of the Metal Elevator Control Arm. Then fit the Elevator Control Lever to the
right side, insert the pin and fix it with a set screw. Secure the Pitch Control Frame with a M3*10 Socket Screw and a collar on
the left side. And attach the Elevator Push Pull Lever to the right side of the Pitch Control Frame as shown. Adjust the two bolts
so that the Pitch Control Frame can move freely without excessive play. Finally, add the two plastic Aileron Levers and the 66.5mm
elevator pushrod. Add the Washers (BK0088) to make sure that the Aileron Lever and the Metal Elevator Parallel Lever will not
touch each other during operation.
(1)
Add Loctite
(4)
(14)
Add Loctite
(17)
Qty.
(7)
(9)
(3)
(15)
No. Material No. Description
1 10 BK0093 Link Rod 2x46
1 11 BK0407 Collar d3xD4x4.5
1 12 BK0410 Collar d3xD4x13
1 13 1-5-1 Aileron Lever Subassembly
2 14 1-5-2 Metal Elevator Parallel Lever Subassembly
1 15 1-5-3 Elevator Control Lever Subassembly
1 16 1-5-4 Pitch Control Frame Subassembly
2 17 1-5-5 Header Tank Subassembly
3
(6)
(13)
(12)
(2)
(11)
16
BAG D
(5)
Add Loctite
66.5mm
(16)
Elevator Control
Pushrod
Qty.
1
2
2
1
1
1
1
1
(8)
(10)