Installation Of Body (Bag; Body Subassembly - THUNDER TIGER Raptor 90 3D Assembly And Maintenance Manual

5-4
Installation of Body
No. Material No. Description
1 5-4-1

Body Subassembly

Carefully cut out the canopy (windshield) using scissors. The
best scissors to use are (TTR 1304) designed to cut RC car
bodies and Canopy. Install the canopy to the body using six
small screws. Drill small holes in the canopy and body for the
holes. Drill two more holes for the rubber grommets.
Refer to color box and apply the decals (In BAG M).
5-4-1 Body Subassembly
No. Material No. Description
1 HMJ2-6B M2x6 Self-Tapping Screw
2 HSE3-12B M3x12 Self-Tapping Screw
3 BK0102 d3xD6x11Grommet
4 BK0098 Body Clip A
5 BK0099 Body Clip B
6 BK0429 Body
7 BK0428 Canopy
8 JV0186 Decal
9 BK0473 Body Support
10 BK0474 Rubber CAP
11 HNLR6 R Pin
BODY SUPPORT INSTALLATION
Insert the aluminum support
tube through the servo frame.
Insert the "R" pins through the
two holes in the support tube
to prevent the tube from
moving in the servo frame.
Install two rubber ends onto
the support tube. The rubber
ends will dampen shake or
vibration generated by the
engine.
Qty.
1
Qty.
6
2
2
1
1
1
1
1
1
2
2
(9)
(11)
(10)
39
BAG J
(1)
Cut a hole at the
front air scoop for
backward flights.
(6)
(3)
(7)
(1)
(5)
(4)
(2)