Pitch Control Frame Subassembly; Elevator Control Arm Subassembly - THUNDER TIGER RAPTOR Assembly Manual

1-5-4 Pitch Control Frame Subassembly

No. Material No. Description
1 HMJ2-10N M2x10 Self-Tapping Screw
2 HMV840ZZ d4xD8x3 BRG
3 HMV1280 d8xD12x3.5 BRG
4 BK0336 Pitch Frame
5 BK0075 Link Ball 4.8
Optional: add a tiny drop of thick CA on the outside rim
of the ball bearings before inserting them into the plastic
Pitch Frame. Be careful not to get any glue into the ball
bearings. Add a tiny drop of thick CA glue at the tip of
the M2x10 self-tapping screw (No. 1) before
screwing it into the Pitch Frame.

1-5-5 Elevator Control Arm Subassembly

No. Material No. Description
1 BK0339 Elevator Control Arm
2 BK0663 Elevator Arm Link
3 BK0413 Pin 2x29
INSTALLATION OF THE RODS
MARK
2
Character No.
2
The two plastic elevator control arms should be attached to the swashplate
steel ball with the molded character number facing the swashplate ball. Because
the hole on the plastic control arm has difference opening sizes on the two
sides. The side with the molded character number has the bigger opening.
Please snap this plastic control arm gently onto the swashplate steel ball and
afterward, please check to make sure it is securely attached and there is no
damage or cracking.
The looped shape plastic control rod should be attached to the flybar control
arm with the molded character facing the steel ball. Please check to make
sure it is securely attached and there is no damage or cracking.
Qty
1
2
2
1
1
(4)
(5)
(1)
Character No.
MARK
Qty
1
2
2
14
(2)
(2)
(1)
(3)
(3)