Landing Gear Installation - THUNDER TIGER Tiger Bipe 40 Assembly Instructions Manual

RADIO
Mount the aileron servo in the bottom wing as
shown. Screw the nylon horns furnished onto
the threaded ends of the aileron torque rods;
screw down until about 1/16" of threads are
exposed above the horn. Use the threaded
rods, clevises, and "Z" bends to link the servo to
the ailerons.
Adjust the linkage so the bottom surface of
the wing is consistent with the bottom surface of
the ailerons when the servo is in neutral.
When all is complete, install the receiver,
switch harness, and battery pack. The receiver
can go in the cutout in the throttle servo tray and
a flat battery pack will fit under the fuel tank.
You may need to reposition the battery to
achieve proper balance.
Mounting Strap
3x12 Self Tapping Screw

Landing Gear Installation

2.6x8 Self Tapping Screw
Steering Horn
3x3mm Set Screw
14
Trim the rear of the cowl to remove the mold-
ing flange. Make cutouts as needed to clear the
prop shaft, cylinder head, carb, and muffler. A
sanding wheel on a Dremel tool is handy for
this.
With the cowl in position, drill 1/16" holes for
the small mounting screws in four places.
Locate them in the white area on the fuselage
side.
After the cowl is mounted, add the sticky
backed trim material to dress up your cowl.
Collar
3x5mm Screw