Advertisement
14
Radio Installation II
6
27
34 66 67 68
1. Thread the clevises
on the
27
pushrods then adjust and attach
the clevises to the servo arm when
servo and rudder are at neutral
position.
2. Thread one end of the Jib Sail
Control String to the servo drum.
Make a Figure Eight Knot in the
drum. Turn on the radio and make
sure the control stick is full down
then wind the string for two turns I
the drum then place the drum o
the winch servo.
3. Tie a Bowline Knot to the Swivel
66
on the other end of the control
zstring. Keep the string about
5/16"(8mm) out of the front winch
line guide(the length is string only
not includes the swivel ). Note: the
less turns of string in the drum the
less chance for string to be out of
the groove.
4. Do the same procedure on the
Main Sail Control String but keep
the string about 3/4"( 20mm) out of
the rear winch line guide(the
length is string only not includes
the swivel ).
5. Do the sail adjustment in page
20 after you satisfied with the
adjustment then secure the drum
with the screw comes with the
servo. Next secure the Winch
Servo Cover
with two Standoff
67
and 3x25mm Wood Screws
68
You will need to trim two notches
for the strings to go.
.
6
Advertisement
