Wash Out Subassembly; Main Gear Subassembly - THUNDER TIGER Raptor 90 3D Assembly And Maintenance Manual

1-6-1 Wash Out Subassembly

No. Material No. Description
1 HMJ2-10N M2x10 Self-Tapping Screw
2 HMC3-12B Socket Screw M3x12
3 HMV840ZZY BRG d4xD8x3
4 BK0088 Washer d3x5x0.5
5 BK0472 Washout base
6 BK0342 Flybar Control Lever
7 BK0343 Washout Link
φ
8 BK0075 Link Ball
9 BK0409 Collar d3xD4x7
10 BK0487 Pin
11 HMS15 E Ring
(2)
Add Loctite
(10)

1-6-2 Main Gear Subassembly

No. Material No. Description
1 HMC3-8B Socket Screw M3x8
2 HMQ16 Retaining Ring
3 BK0357 Tail Drive Spur Gear 83T
4 BK0359 One Way Clutch Shaft
5 BV0368 Auto Rotation Hub
6 BK0356 Main Spur Gear 91T
It is necessary to add grease inside the one way clutch before your
first flight. The clutch might lock up once grease is gone. The one
way clutch grease( PV0517) is recommended for this lubrication.
Make sure the inside of Auto Rotation Hub is clean without any dirt
before you insert the one way clutch shaft.
PV0517 ONEWAY BEARING GREASE
Insert the pin into the Washout Link. Add a tiny drop of Loctite on the inside
Qty.
and outside of BK0409 Collar which will help give a completely slop free
2
control system. Do not let the Loctite seep into the bearing. Adjust the
2
tightness of the M3x12 bolts so the mixing arms can move freely but without
4
wobble or racheting the ball bearings. Add a tiny drop of thick CA glue at
2
the tip of the M2x10 self-tapping screw (No. 1) before screwing it into the
1
Flybar Control Levers (No. 6).
2
2
4.8 2
2
2
2
(9)
(3)
(11)
(5)
Qty.
(8)
(1)
(4)
(6)
4
1
1
1
1
1
20
(7)
(2)
(4)
(1)
Add Loctite
(6)
(5)
(3)