Tail Assembly (Bag G) - THUNDER TIGER Raptor 90 3D Assembly And Maintenance Manual

3-1
Tail Assembly
No. Material No. Description
1 HMC3-30B Socket Screw M3x30
2 HMC3-14B Socket Screw M3x14
3 HMM3Z Locknut M3
4 BK0086 Ball Link 4.8x20
5 BK0278 Machined Washer
6 BK0403 Rod Guide
7 BK0404 Tail Rotor Blade
Assemble the tail transmission subassembly according to 3-
1-1 and 3-1-2 first. And the tail drive shaft subassembly according
to 3-1-3.But do not close the two halves of the tail transmission
tightly. You will do this when you are ready to install the gearbox
onto the tail boom.
When installing the tail transmission, make sure the housings
match the hole on to the tail boom. Add Carbon Vertical Fin with
machined washer and Locknut, then tighten the five 3 mm bolts.
Add carbon Vertical Fin with Pom washer and Locknut.
Before inserting the finished tail drive shaft assembly into the
tail boom, add some flexible silicone glue or ZAP Goop glue
around the outside of the tail drive bearing housing. This will
prevent the bearing housing from spinning inside the tail boom.
(7)
(2)
(1)
(5)
(13)
(4)
(10)
Qty. No. Material No. Description
2 8 BK0877 3D Vertical Fin
2 9 BK0650 Tail Boom
4 10 BK0707 Rear Servo Rod
2 11 BK0347 Tail Push Rod A
2 12 BK0653 Tail Push Rod B
4 13 3-1-1 Tail Transmission Subassembly
2 14 3-1-3 Tail Drive Shaft Subassembly
Slide four No. 6 Rod Guides onto the tail boom. Do not glue
them onto the tail boom yet. Add a tiny drop of CA glue to the
pushrod guide after you finish building the entire helicopter.
Before adding glue, make sure the tail pushrod is hooked up
to the servo and the rod travels in a straight line and moves
very smoothly.
(8)
(3)
(6)
(9)
Add flexible silcone glue or ZAP
Goop glue around the outside
before inserting into the tail
boom from the front side.
26
BAG G
Qty.
1
1
1
1
1
1
1
(14)