Display And Checking Of The Settings - Leica GEOVID 402 Instruction Manual

Setting of the
EHr
If the device is switched on: Wait until the display
goes out. If the device is not switched on: Start with
Step 1.
1. Hold the auxiliary button (1) depressed (≥4s).
• appears.
USEU
2. Press the auxiliary button 1x briefly.
• The display changes.
3. Select the desired setting (
pressing the main button (2) several times.
4. Save your setting by briefly pressing the auxiliary
button.
• The save setting is displayed for 4s for
confirmation, then the display goes out.
/ ) by
EHr ON OFF
32

DISPLAY AND CHECKING OF THE SETTINGS

If you wish to check your settings, you can display
the values at any time.
Press the auxiliary button 2x briefly.
• Below the target mark, the following are displayed
in turn for approx. 2s (possibly instead of the
range):
– The set units system (
– (only if the function is activated)
EHr
or )
EU US