Customer Information - Installation Procedures - Rinnai SLIMFIRE 25 Customer Operation & Installation Manual

CUSTOMER INFORMATION - INSTALLATION PROCEDURES

• Preparation
Refer to the Location and Flueing sections
on pages 10-12 to make sure the decorative
fireplace cavity is suitable for installation
before continuing.
Place the heater on a flat surface.
Remove the three screws holding the front
fascia in place. (1)
Pull the bottom of the facia forward until clear
of the gas control buttons and lift up to
remove from frame.
Remove the two screws holding the top glass
retainer in place and lift off glass retainer. (2)
Loosen the two screws holding the lower
glass retainer in place and remove glass
panel. (3)
Remove the barrel elbow from the gas
connection bracket on the base of the heater
at the front right hand side. Make sure that
the gas flare fitting and gas supply pipe are
clean and free of damage and fit together
ready for fitting to the heater. (4)
1
IBF - Slimfire 25
2
7
3
• Installation
For installation into a non-combustible fire
place the foam strips supplied must be
attached to the heater as shown (5)
provide a seal around the fire place (if this
does not provide
alternative must be used).
Insert the heater into the cavity. Take care
when inserting the gas supply tube into the
heater not to damage the tube or any of the
components inside the heater.
There are four levelling screws (6) in the
base of the heater held in place with
locknuts. If the heater does not sit flat when
in place, it may be necessary to adjust these.
The front screws are accessible with the front
of the heater removed. If adjustment of the
rear feet is required the burner assembly and
gas control will need to be removed.
Once the heater is sitting flat attach it to the
wall using the four holes (two per side) in the
front flanges.
10
11
6
9
- 14 -
to
adequate seal an
5
8
4
Issue 5 - ©Rinnai