Chapter 2 Web-Based Configuration; Prerequisites - H3C S1526 User Manual

User Manual
H3C S1526 Smart Ethernet Switch

Chapter 2 Web-based Configuration

The S1526 has a built-in Web server, through which you
can manage and maintain the switch conveniently.

2.1 Prerequisites

Your computer
requirements before you can access the Web page to configure
the switch, assuming that you have installed the switch and
connected all necessary cables.
I. Computer system/hardware
Operating system installed (Windows XP/2000)
Network card installed
Web browser installed (Microsoft IE5.5 or later
version)
TCP/IP protocol suite installed and enabled (refer to
Chapter 5
II. Network configuration
For local configuration, make sure that the IP address
of the computer and the management IP address of
the switch are in the same subnet before accessing
the configuration page (refer to
– IP
configuration, make sure the route connectivity
between the computer and the switch is good. The
should
" Appendix – TCP/IP Installation
Address Configuration
2-1
Chapter 2 Web-based Configuration
meet the following
Chapter 6
");
basic
")
" Appendix
For remote