Rate Limit - H3C S1526 User Manual

User Manual
H3C S1526 Smart Ethernet Switch
Packet
Deferred error
Collisions error
Late collisions
error
Note:
Cyclic redundancy check (CRC) is a technology whereby to
check the errors of a data frame.

2.5.5 Rate Limit

With the rate limit enabled, the rate of packets coming into
or leaving the port will be limited, to ensure the smooth
operation of the network.
Click [Port/Rate Limit] to enter the [Rate Limit] page, as
shown in Figure 2-17
of each port. The symbol "--" indicates that no rate limit is
applied. Click a port number to enter the [Rate Limit
Configuration] page, as shown in
set the rate limit for the port.
Chapter 2 Web-based Configuration
The number of packets transmitted by a
port for which the first transmission
attempt is delayed because the medium
is busy.
The number of collisions experienced
by a port during packet transmissions.
The number of times a collision is
detected later than 512 bit-times into
the transmission of a packet.
, where you can see the rate limit status
Figure 2-18
2-26
Description
, where you can