Chapter 5 Appendix - Tcp/Ip Installation - H3C S1526 User Manual

User Manual
H3C S1526 Smart Ethernet Switch
Chapter 5 Appendix – TCP/IP
The PC through which you configure the S1526 must have
the TCP/IP protocol suite installed. If you are not sure whether
TCP/IP is installed, follow these steps.
Caution:
The following steps are based on Windows 2000.
1) Choose [Start/Settings/Control Panel]. Double-click
the [Network and Dial-up Connection] icon to open the
[Network
connection and then select [Properties] to check if
TCP/IP has been installed to the designated network
interface card on the computer. If not, click <Install>.
Installation
Connection]
5-1
Chapter 5 Appendix – TCP/IP
window. Right-click
Installation
one