Table of Contents
Advertisement
C H A P T E R 3
Using your interactive whiteboard system
Adjusting the image
Refer to these notes when adjusting the projected image as described in the SMART Board 880i6
and 885i6 interactive whiteboard system installation guide included (smarttech.com/kb/170499).
Whilst adjusting the projected image size, shape and location, use the projector's default
l
background so that you can see the full projected image clearly. Don't use other images,
which might be cropped or scaled by the projector and could result in a misleading projected
image size, shape and location.
Use the mechanical adjustments described in the installation document to make all physical
l
image adjustments. Don't use the projector's on-screen menu options during the projector
alignment process.
Be aware that as you tilt the projector up or lower its mounting boom to raise the image, the
l
entire projected image increases or decreases in size, especially at the bottom of the
projected image.
When adjusting keystone (tilt), ensure that the top and bottom edges of the image are
l
horizontal before you position the left and right edges of the image relative to your interactive
whiteboard.
When you move the projector forward or backward on the boom to make the image larger or
l
smaller, you might need to tilt or turn the projector slightly to keep the image square. Loosen
the lever slightly to aid in this adjustment.
To fine-tune the image, you might need to repeat all steps described in the installation
l
document in smaller increments.
Projector connection diagram
You can connect a variety of peripheral devices to your projector, including DVD/Blu-ray players,
VCRs, document cameras, digital cameras and high-definition sources, as well as peripheral
device outputs, such as a secondary projector or a flat-panel display and powered speakers.
N O T E
You might need to purchase third-party adapters to connect certain peripheral devices.
1
2
3
7
8 9
4
5
6
21
11 12
13 14
10
Advertisement
Table of Contents
