SMART Board 800i6 Configuration And User's Manual page 28

C H A P T E R 3
Using your interactive whiteboard system
Setting Use
V-Position Moves the vertical position
of the source video up or
down from -5 to 5 (relative to
the projected image).
White Peaking Adjusts the image colour
brightness from 0 to 10
whilst providing more vibrant
white shades.
Degamma Adjusts the colour
performance of the display
from 1 to 3.
Colour Adjusts the Red, Green,
Blue, Cyan, Magenta and
Yellow colours on the
projector from 0 to 100 to
provide custom colour and
luminance output.
Audio menu
Volume
Mute Mutes the projector's audio
output.
Disable Volume Disables the projector's
Control volume control and the
ECP's volume control knob.
Enables/disables the line
Line out
out.
Microphone Enables/disables the
microphone
Speaker Enables/disables the
speaker
15
Notes
Don't adjust this setting unless you're advised
to by SMART Support.
Apply this setting only after you make all boom
adjustments.
This setting applies to VGA inputs only and is
useful in situations where the source video is
cut off.
A value closer to 0 creates a natural image and
a value closer to 10 enhances brightness. The
default is 10.
The default is 2.
Each colour has a default value of 100.
Adjustments to the colour settings register
under the User mode.
The default is off.
If you mute the projector's audio output and
then increase or decrease the volume, the
volume is restored automatically. You can
prevent this from happening by disabling the
volume control.