Commander Touch User Guide
Step 2: Install the Commander Touch Tuner Module
The Commander Touch Tuner Module should be installed and secured behind the dash or center
console using wire ties (not included) . Keep in mind that you will need to route several cables to the
Tuner Module, so allow enough clearance for the cable connections .
1. Find a location for the Tuner Module with suitable
clearance for the cable connections .
2. Thread the wire ties through the molded brackets on
the underside of the Tuner Module as shown . Secure
the Tuner Module to a bracket or wiring harness
using the wire ties . Avoid brackets with sharp edges
and any moving parts such as gas, clutch, and brake
pedals .
3. Connect the cable from the Display Controller to the
DISP connection on the Tuner Module .
Introduction
Display Connector
11