Sirius XM RAdio commander touch User Manual page 25

Commander Touch User Guide
update, the process cannot be interrupted .
6. You can provide uninterrupted power to your Commander Touch for the duration of the
software update .
Software Update Instructions
Commander Touch must remain on during the entire software update process . If power is
interrupted during the software update process your Commander Touch will become damaged .
1. Go to siriusxm .ca/commandertouch and download the software update file . This file will be
named SXVCT1_SW_Update_vxx .xx .xx .zip . (xx .xx .xx is the software version number .)
2. Open the ZIP archive and extract the software update file(s) to a folder on your computer . They
will be named SXVCT1_S .xxx and/or SXVCT1_N .xxx .
3. Copy any files you may have off of your USB Flash Drive to another location, and then erase or
reformat (FAT32) the USB Flash Drive . Copy the SXVCT1_S .xxx and/or SXVCT1_N .xxx file(s) to
the root directory of the USB Flash Drive . Do not put them in a folder on the drive .
4. You will need access to the USB port on the bottom of the Display
Controller . If the Display Controller is mounted in the Flush Mount,
remove the Display Controller from the Flush Mount using the
Release Tool . Center the tool on the right side and press in between
the Display Controller and the Flush Mount until the latch releases .
(You may need to rock it gently from side to side slightly to release
the latch .) Then pry the Display Controller out of the Flush Mount .
5. Turn your Commander Touch on . This may require you to
turn the ignition in your vehicle to ACC to provide power
to Commander Touch . Wait until Commander Touch is
completely powered on .
6. Connect the USB Flash Drive to the USB port on the
bottom of the Commander Touch . Use the adapter or
adapter cable, if necessary .
7. Swipe to Settings, swipe up or down if necessary, tap
the About button, and swipe up to the second page .
8. If the software update only included the file named
SXVCT1_S .xxx, tap DCU/DLP Software Update . If the
software update only included the file named
SXVCT1_N .xxx, tap NAND Image Update . If the software
update included both files, perform the DCU/DLP
Software Update first, and then repeat this procedure to
perform the NAND Image Update .
9. You will be prompted to begin the software update . Tap
Update to proceed .
10. If there are any problems in reading the file on the USB
Flash Drive, you will be alerted by an advisory message,
and the software update will be aborted .
Introduction
Micro USB Port
25