Step 5: Connect The Magnetic Mount; Antenna And Powerconnect Power - Sirius XM RAdio OnyX User Manual

Vehicle Installation
logos . Be careful not to crimp or cut the cable .
5. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console . Coil any excess
cable in a hidden location, such as under the carpet, keeping it away
from any vehicle pedals or controls . Secure the excess cable with wire
ties (purchased separately) .
6. Bring the end of the cable out at the PowerConnect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it to
the antenna connector of the dock .
7. Continue with "Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter" on page 34 .
Sedan/Coupe With Antenna Placed at the Front of the Roof
1. Feed the antenna cable from the antenna underneath the rubber
molding around the windshield . Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the windshield and
tuck the antenna cable underneath the molding . Route the antenna
cable around and down the windshield to the lowest point .
2. At the lowest corner of the windshield, route the cable out of the
windshield molding and into
the rubber weather stripping
around the door opening . Lift
the weather stripping from the
opening and tuck the cable
inside it, then replace the
weather stripping . Run the cable
inside of the weather stripping
to the bottom of the door
29