Sirius XM RAdio commander touch User Manual page 18

Hide thumbs Also See for commander touch:
Table of Contents

Advertisement

Introduction
Pickup Truck
1. Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around the
windshield and tuck the antenna cable underneath it .
2. Continue tucking the cable underneath the windshield molding around the windshield to the
lowest corner .
3. At the lowest corner of the windshield, route the cable out of the windshield molding and into the
rubber weather stripping around the door opening . Lift the weather stripping from the opening
and tuck the cable inside it, then replace the weather stripping . Run the
cable inside of the weather stripping to the bottom of the door opening .
4. Pull the cable out of the weather stripping at the bottom of the door
opening and route it under the carpet toward the dashboard . Coil any
excess cable in a hidden location, such as under the carpet, keeping it
away from any vehicle pedals or controls . Secure the excess cable with
wire ties .
5. Bring the end of the cable out at the PowerConnect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it to the
antenna connector of the dock .
6. Connect the antenna connector to the ANT connection of the Tuner Module . Note: Use only
SiriusXM approved antennas .
18
Commander Touch User Guide
Antenna

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents