Sirius XM RAdio commander touch User Manual page 10

Introduction
6. Once the Flush Mount is secured in place, insert
the Commander Touch Display Controller into the
Flush Mount . First, route the cable from the left
side of the Display Controller into the opening
at the bottom left of the Flush Mount, and then
gently press the Display Controller into the Flush
Mount, left side first and then the right side . It
will snap into place .
7. Route the cable from the Display Controller to
the place behind the dash or center console
where you plan to install the Tuner Module .
(Refer to the next step .)
Removing the Display Controller from the Flush Mount
To remove the Display Controller from the Flush Mount
use the Release Tool . Center the tool on the right side
and press in between the Display Controller and the
Flush Mount until the latch releases . (You may need to
rock it gently from side to side slightly to release the
latch .) Then pry the Display Controller out of the Flush
Mount .
10
Commander Touch User Guide