Sirius XM RAdio commander touch User Manual page 17

Commander Touch User Guide
5. Connect the antenna connector to the ANT connection of the Tuner
Module . Note: Use only SiriusXM approved antennas .
Sport Utility Vehicle (SUV)
1. Feed the antenna cable underneath the rubber weather stripping of the
rear tailgate window/door and route the cable along the rear hatch . Lift the weather stripping
from the opening and tuck the cable inside it, then replace the weather stripping . Pull the cable
out from weather stripping and route it into the cabin under the interior trim . Avoid hinges or
gears that could crimp or cut the cable .
2. Route the cable through the SUV's main cabin area under the
interior trim, towards the front of the vehicle . Use a blunt plastic
putty knife or similar blunt tool to lift the plastic trim just enough
to tuck the cable under underneath . Avoid side airbag locations
on back pillars and above the doors . Airbag locations are marked
with "SRS" logos . Be careful not to crimp or cut the cable .
3. Bring the cable out from the trim near the front of the cabin and
route it under the carpet toward the dashboard or console . Coil
any excess cable in a hidden location, such as under the carpet,
keeping it away from any vehicle pedals or controls . Secure the excess cable with wire ties
(purchased separately) .
4. Bring the end of the cable out at the PowerConnect Vehicle Dock location . Leave yourself
enough cable so you can easily connect it to the antenna connector of the dock .
5. Connect the antenna connector to the ANT connection of the Tuner
Module . Note: Use only SiriusXM approved antennas .
Convertible
1. Bring the antenna cable from the antenna into the trunk at the front
edge of the trunk lid . Keep any bends in the cable loose . Tape or tie the cable along the inside of
the trunk lid to the trunk lid hinge strut .
2. Allow enough slack in the cable so the trunk lid can easily open and close and keep the cable
away from hinges, gears, etc ., that could crimp or cut it . Route the cable along the trunk wall and
into the cabin through a conduit or along an existing wiring harness .
3. Route the cable through the main cabin area under the interior trim,
towards the front of the vehicle . Use a blunt plastic putty knife or
similar blunt tool to lift the plastic trim just enough to tuck the cable
under underneath . Avoid side airbag locations on back pillars and
above the doors . Airbag locations are marked with "SRS" logos . Be
careful not to crimp or cut the cable .
4. Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console . Coil any excess
cable in a hidden location, such as under the carpet, keeping it away from any vehicle pedals or
controls . Secure the excess cable with wire ties (purchased separately) .
5. Bring the end of the cable out at the PowerConnect Vehicle Dock location . Leave yourself
enough cable so you can easily connect it to the antenna connector of the dock .
6. Connect the antenna connector to the ANT connection of the Tuner Module . Note: Use only
SiriusXM approved antennas .
Introduction
Antenna
Antenna
17