Polycom ViewStation 128 Manual page 17

To test whether the PolyCom ViewStation 128 microphone is properly
connected and picking up audio, follow these steps:
© Copyright 2006, Oregon State University Extension Service
From the Audio screen use the
on the remote control to highlight the
"Generate Tone" option. Press the
in the middle of the arrows on the remote
control.
From the Generate Tone screen press the
button in the middle of the arrows on the
remote control to select the picture of the speaker.
You should hear a tone. If you do not hear the tone
check the volume on the television set, check the
audio cables from the PolyCom ViewStation 128
device to the television, and call your support
phone number if you still cannot make it work. See
page 24.
From the main screen use the
on the remote control to highlight the
"System Info" option in the upper right corner of
the screen. Press the
middle of the arrows on the remote control.
From the System Information screen use the
arrow buttons
highlight the "System Info" option in the lower left
corner. Press the
middle of the arrows on the remote control.
Page 17 of 24
http://extension.oregonstate.edu/esoc/ectu/
red arrow
red enter
red arrow
red enter button
on the remote control to
red enter button
buttons
button
red enter
buttons
in the
red
in the