Testing The Audio - Polycom ViewStation 128 Manual

Hide thumbs Also See for ViewStation 128:
Table of Contents

Advertisement

Testing the audio:

Depending on your setup you may occasionally need to test the audio
connections for your PolyCom ViewStation 128. Though this will happen
rarely, it is important to know how to perform these two tests. This
section will show you how to test the audio connections to the television
and test the microphones.
This is a good place to look if you are having audio problems.
To test whether the PolyCom ViewStation 128's audio is properly
connected to the television, follow these steps:
© Copyright 2006, Oregon State University Extension Service
From the main screen use the
on the remote control to highlight the
"System Info" option in the upper right corner of
the screen. Press the
middle of the arrows on the remote control.
From the System Information screen use the
arrow
buttons
highlight the "System Info" option in the lower left
corner. Press the
middle of the arrows on the remote control.
From the Diagnostics screen use the
buttons
the "Audio" option. Press the
in the middle of the arrows on the remote control.
Page 16 of 24
http://extension.oregonstate.edu/esoc/ectu/
red arrow
red enter
button
on the remote control to
red enter
button
on the remote control to highlight
red enter
buttons
in the
red
in the
red arrow
button

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ViewStation 128 and is the answer not in the manual?

Questions and answers

Table of Contents