Record Table Search; Figure 69 - Record Table Search Screen - Eneo DLR4-08 Operating Instructions Manual

Operating Instructions
Highlight the box beside Motion and press the
of motion detection.
Highlight the box beside Video Loss and press the
reports of lost video.
Highlight the box beside Video Blind and press the
reports of blind video.
Highlight the box beside Text-In and press the
of text input.
Highlight the box beside Record Channels and press the
for any reports of event recorded data. The DVR will display the events (not the camera channels) that occurred and
that also are recorded on the camera channel that you selected. If you do not select a camera channel in this field, the
DVR will search events that are not associated with cameras.
You can also toggle On and Off self-diagnostic System Events as part of your search. The choices are:
Panic Record
Check Recording
Check Alarm-In
Disk Almost Full
Disk Bad
Disk Temperature
Disk S.M.A.R.T.
Fan Error
Once you set your desired search conditions, highlight Search and press the
the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.

Record Table Search

< Compact View >
< Standard View >
< Expanded View >
Figure 69 — Record Table Search screen.
52
button. You can select the cameras for which you want any reports
button. You can select the cameras for which you want any
button. You can select the cameras for which you want any
button. You can select the text-in devices which you want any reports
button. You can select the cameras that you want to search
Recording information about video images currently displayed
on the screen displays on the recording status bar. A grey
vertical line indicates the current search position. To search
specific video, move the vertical line by using the Left or
Right arrow buttons on the front panel or by clicking the
mouse on the desired segment.
If the DVR's time and date have been reset to a time that is
earlier than some recorded video, it is possible for the DVR to
have more than one video stream in the same time range. In
this case, the overlapping time range in the record table will
be separated by a yellow vertical line .
NOTE: The recorded data in the time range located after
the yellow vertical line is the latest.
button to display the search results in