Block Setting - Mitsubishi Electric AG-150A Instruction Book

4-5 Block Setting

By performing block settings, multiples of air conditioner groups can be collectively monitored or operated from
the Web or TG-2000A. It also enables energy-save/peak cut controls. Bring up the Block Setting screen by
clicking [Initial Settings]-[Blocks] in the menu, and register the groups in the block to utilize these features.
Click [Save Settings] to send setting data to the AG-150A.
Note: If the user logs in as a building manager, some of the operations may be prohibited.
Note: If the system is connected to the TG-2000A, make all settings and changes from the TG-2000A so that the data in
TG-2000A and AG-150A will match.
Block Name
Register the block name to be
displayed on the Web screen
here.
Refresh
Read setting data from AG-150A.
4-5-1 Registering a block name
In the [Block Name] field on the screen, register the block name to be displayed on the Web screen, using a
name consisting of no more than 20 characters
Note: The following characters cannot be used in the group name: < > & " '
4-5-2 Registering a group in a block
Click on the Group Registration field to display [Select Groups], and click
on the numbers corresponding to the groups to be registered. The ones
that are selected will be shown with a yellow-green background. (Putting
a cursor on the group number will display the group name.) To cancel
the selection, click on them again. Deselected items will be shown with a
gray background.
Note: If PAC-YG50ECA Expansion Controllers are connected, Expansion Controller
system selection buttons will appear. Select the desired Expansion Controller (EC1,
EC2, or EC3), and make the settings for each system. Make the settings with the
Expansion Controllers properly connected.
Expansion Controller
system selection buttons
22
Group Registration
Register the groups to be
included in the block here.
Save Settings
Send setting data to AG-150A.