Function Setting - Mitsubishi Electric PUZ-SM100VKA2 Service Manual

FUNCTION SETTING

10
10-1. UNIT FUNCTION SETTING BY THE REMOTE CONTROLLER
Each function can be set as necessary using the remote controller. The setting of function for each unit can only be done by
the remote controller. Select function available from the <Table 1>.
<Table 1> Function selections
(1) Functions available when setting the unit number to 00 (Select 00 referring to 4 setting the indoor unit number.)
Function
Power failure OFF
automatic recovery ON
Indoor temperature Average data from each indoor unit
detecting Data from the indoor unit with remote controller
Data from main remote controller*
LOSSNAY
Not supported
connectivity
Supported (Indoor unit does not intake outdoor air through LOSSNAY)
Supported (Indoor unit intakes outdoor air through LOSSNAY)
Power supply
240 V
voltage 220 V, 230 V
Frost prevention 2: (Normal)
temperature 3:
Humidifier control When the compressor operates, the humidifier also operates.
When the fan operates, the humidifier also operates.
*The function is available only when the wired remote controller is used. The functions is not available for floor standing
models.
Meaning of "Function setting"
mode02:indoor temperature detecting
No Indoor temperature(ta)=
No.1 Average data of the
sensor on all the
indoor units
No.2 The data of the sensor
on the indoor unit that
connected
with remote controller
No.3 The data of the sensor
on main remote
controller.
(2) Functions available when setting the unit number to 01-02 or AL (07 in case of wireless remote controller)
Refer to the service manual that comes with each indoor unit.
10-2. SELECTING FUNCTIONS USING THE REMOTE CONTROLLER
Refer to "14-3. SERVICE MENU" and "14-5. FUNCTION SETTING" when selecting functions.
OCH774A
Settings
OUTDOOR
INDOOR INDOOR
REMOTE REMOTE
(MAIN) (SUB)
Initial ta=(A+B)/2
setting
Initial ta=A
setting
Initial ta=C
setting
Mode No. Setting No.
1
01
2
1
02 2
3
1
2
03
3
1
04
2
1
15
2
1
16
2
OUTDOOR
INDOOR INDOOR
REMOTE REMOTE
(MAIN) (SUB)
ta=(A+B)/2
ta=B
ta=C
74
: Initial setting
Remarks
(when sent from the factory)
The setting is
applied to all
the units in the
same
refrigerant
system.
OUTDOOR OUTDOOR
INDOOR INDOOR
REMOTE REMOTE REMOTE
(MAIN) (SUB) (MAIN)
ta=A ta=A
ta=A ta=A
ta=C ta=C