Mitsubishi Electric AG-150A Instruction Book page 25

5-1-2 Setting the Mail Server Information
Enter the mail server information provided by either the ISP or
the LAN administrator.
Either the IP address or the host name (server name) can be
entered in the mail server field.
Make necessary settings depending on the functions to be used, using the table below as a reference.
Table 5-2 Items that Require Settings to Be Made (Mail Server Information)
Items
Outgoing Mail Server (SMTP)
SMTP Authentication
Incoming Mail Server (POP3)
DNS Server (Primary)
DNS Server (Secondary)
5-1-3 Setting the Error Mail Destinations
(1) Enter the title of the error mail that will be sent from
AG-150A in the [Mail Title] field. The title may contain a
maximum of 40 characters.
Note: The following characters cannot be used in the mail title:
< > & " '
(2) Choose the error type out of the following: [Unit Error], [Preliminary Unit Error], [Communication Error],
[General Equipment] and [User Setting 1] through [User Setting 6]. Then enter the mail address of the
recipient of the error mail.
(3) To send error messages only upon occurrences of certain
errors, click the User Setting button that appear when "User
Setting 1" through "User Setting 6" are selected, and
register the error codes to be reported in the user settings.
A maximum of 20 error codes can be set for each user
setting. In addition to specific error codes such as [1302] or
[6607], codes such as [10**] or [12**] can also be used. If
[10**] is set, for example, error mail will be sent upon an
occurrence of any type of errors between [1000] and [1099].
If error codes are set on this screen, confirm that the
address of the recipient is registered.
Error Mail Report
Functions
No SMTP
Authentication
V
IP Address or
Host Name
*1
(V)
*1
(V)
Uses SMTP
Authentication
V
Host Name
V
V
V
*1: Not necessary if the IP address is used as the mail server address.
24
Mail Communication
No SMTP Uses SMTP
Authentication Authentication
V
IP Address or
Host Name
Host Name
V
IP Address or IP Address or
Host Name Host Name
*1
(V)
*1
(V)
V
V
V
V
V