Table of Contents
Advertisement
After calling up the menu, you will see the
following on-screen display:
The
buttons allow you to select
the parameters you want to change for the
search.
Satellite and position
Use the
buttons to select the satellite that is transmitting the channels to be searched. By pressing
the
button at this point, you can view a list of the installed satellites. Use the
satellite you want and confi rm your selection with the
these satellite(s).
Transponder frequency
Use the
buttons (transponder frequency already stored) or the number pad (transponder frequency
not yet stored) to select the transponder frequency on which the channel being sought is transmitted. By
pressing the
button at this point, you can view a list of the transponders stored for the selected satellite.
Use the
buttons to select the transponder you want and confi rm your selection with the
the bottom right of the screen display, the receiver will show the current signal strength and signal quality of
the selected transponder.
The "DVB Type", "FEC", "Polarisation" and "Symbol Rate" options only need to be specifi ed if the
transponder has yet to be stored.
DVB type
Press the
buttons to select whether you want to search for standard channels (DVB-S (SD)) or for
HDTV channels (DVB-S2 (HDTV)).
Error rate
Press the
buttons to select the applicable error rate (Viterbi rate). When searching for DVB S(SD)
transponders, you need not state the error rate. "Automatic" will appear permanently instead. When search-
ing for DVB S2(HD) transponders, you must state the correct error rate. Either QPSK 1/2, 2/3, 3/4, 3/5, 4/5,
5/6, 8/9, 9/10 or 8PSK 2/3, 3/4, 3/5, 5/6, 8/9 or 9/10.
Main menu - Channel search
Search with Service ID
button. Make sure your receiver is aligned to this/
buttons to select the
button. At
95
Advertisement
Table of Contents
