Using Microsd Card - Panasonic TH-55AF1U Operating Instrctions

Stick PC
USB cable (commercially available)
HDMI extension cable (commercially available)
Pin assignments and signal names for USB Terminal
1
Pin No.
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5V/1A can be supplied to an external
device when the picture is displayed.
●
If the electric current exceeding the power supplying
capability is applied, the output is blocked, and the
following message is displayed.
[USB DC5V OUT overload. Please remove cable or
equipment, then turn the display off/on.]
In this case, remove the equipment and then turn the
power off/on using the remote control, etc.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
● Depending on the USB memory, the access lamp
may remain blinking even when it is not being
accessed. In this case, remove the device after
switching to the input other than USB.
Also, when data cloning is running, remove the device
after the screen to notify it is finished is displayed.
(see page 107)
2 3 4
Signal name

Using microSD card

By attaching a microSD card (commercially available)
to the microSD card slot, use it as external storage for
OpenPort PLATFORM system.
(see page 47)
■
microSD card usable on this unit
The following microSD card compliant with SD standard
can be used on this unit.
(Such cards are referred to as microSD card in this
manual.)
microSD memory card (64 MB to 2 GB)
•
microSDHC memory card (4 GB to 32 GB)
•
Only the Fat16-formatted microSD card and FAT32-
formatted microSD card can be used on this unit.
■
To insert or remove the microSD card
microSD card
cover
Screw
1 Using a driver, loosen the screw of the microSD
card cover (anti-theft cover), and remove the
cover.
2 Make the surface of the microSD card face back
side of the unit, and insert it securely until a
clicking sound is heard.
●
For removal, push in the card until it clicks, and pull
it out straight.
3 Attach the cover to the original position.
Note
● Do not touch the connection terminal of the
microSD card.
●
Before attaching or removing the microSD card
cover, turn the unit off with <Main Power On / Off
button>.
●
Be careful not to lose the removed cover. Be sure
to attach it to the original position.
●
While the microSD card is operating, do not turn
this unit off, pull out the microSD card, or subject
this unit to vibration, shock or static electricity.
Saved data, etc. may be lost, or malfunction may
occur.
● When removing a microSD card, unmount the SD
card. (see page 57)
● Do not insert non-standard microSD cards, or
cards other than the microSD card.
Malfunction may occur.
microSD card
Surface
29
English