Step 2 - Connect Fuel - Sportsman GEN9000DF Instruction Manual

Figure 1 - Unscrew the Oil Cap Figure 2 - Add Oil To TOP Of Threads
Step 2 – Connect Fuel
Sulfur, water, dust, etc. are harmful for engine. If the gas supply source (LPG) contains these harmful elements, user must use filter to remove sulfur,
water etc. and clean gas. Otherwise, the engine service lifetime will be shortened.
Choose either LPG or Gasoline fuel. If using LPG, first connect the regulator that was included with the generator to Propane Fuel Tank, then
connect the other end to the Gas Inlet. (Fig A) Make sure the LPG cylinder is vertical and securely positioned
If using gasoline fuel, add Unleaded gasoline only with an octane rating of 87 or higher.
Pre-Operation Check List
Step 1 Check that the gas supply source is in good condition. Check that the gas inlet connection is tightly fixed and not leaking.
Step 2 CHOKE VALVE GRIP is at CHOKE (CLOSE) position. The generator may be hard to start if CHOKE VALVE GRIP is at RUN
(OPEN) position.
Step 3 Check if engine oil is full.
Step 4 Make sure GROUND TERMINAL is properly grounded.
Step 5 AC OUTPUT no load connected.
Disconnect all electrical loads from the generator set before starting the engine. The generator may be hard to start if a load is connected.
Step 6 DC OUTPUT no load connected.
GEN9000DF 9000 Surge Watt / 7500 Running Watt Portable Dual Fuel LPG Liquid Propane Gas & Gasoline Electric Start Generator Manual 12