Step 2 - Connect Fuel - Sportsman GEN2200DFI Instruction Manual

2200 surge watts / 1800 running watts dual fuel lpg liquid propane & gasoline inverter portable generator
Table of Contents

Advertisement

Step 2 – Connect Fuel
Sulfur, water, dust, etc. are harmful for engine. If the gas supply source (LPG) contains these harmful elements, user must use filter to remove sulfur,
water etc. and clean gas. Otherwise, the engine service lifetime will be shortened.
Choose either LPG or Gasoline fuel. If using LPG, first connect the regulator that was included with the generator to Propane Fuel Tank, then connect
the other end to the Gas Inlet. (Fig A) Make sure the LPG cylinder is vertical and securely positioned
If using gasoline fuel, add Unleaded gasoline only with an octane rating of 87 or higher.
Maximum Capacity: 1.0 Gallons
Pre-Operation Check List
Step 1 Check that the gas supply source is in good condition. Check that the gas inlet connection is tightly fixed and not leaking.
Step 2 CHOKE VALVE GRIP is at CHOKE (CLOSE) position. The generator may be hard to start if CHOKE VALVE GRIP is at RUN
(OPEN) position.
Step 3 Check if engine oil is full.
Step 4 Make sure GROUND TERMINAL is properly grounded.
Step 5 AC OUTPUT no load connected.
Disconnect all electrical loads from the generator set before starting the engine. The generator may be hard to start if a load is connected.
Step 6 DC OUTPUT no load connected.
Closed
ON
Open
OFF
Regulator
GEN2200DFI 2200 Surge Watt / 1800 Running Watt Portable Dual Fuel LP Liquid Propane & Gasoline Inverter Generator Manual
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents