Sabbath Feature Mode - Electrolux EW30CC55G B Series Use & Care Manual

23
Setting Surface Controls

SABBATH FEATURE MODE

When the Sabbath feature is ON "Sb" will be showed on the radiant elements control
displays and on the Minute Timer Control display (Fig. 1). On induction element control
displays will be showed "-". Only radiant surface elements can be used during Sabbath
mode. The Timer feature is locked during the Sabbath mode. The warm feature doesn't
work during Sabbath mode.
To activate the Sabbath Feature Mode:
To activate the Sabbath feature at least one radiant cooking surface has to be active. If an
induction element surface is ON it will be automatically turned OFF when the Sabbath
mode is activated. Touch and hold for few seconds simultaneously key of the Minute
Timer Control and key. After few seconds, "Sb" will be showed on the radiant elements
Fig. 1
lock
control displays and on the Minute Timer Control display and "-" will be displayed on
induction element control displays.
To turn ON a Surface Element (only for radiant element) when the Sabbath Feature
is active:
Use the procedure as for operating a Radiant Element. If you turn ON a radiant surface
element during Sabbath mode the electronic surface element control will record the
request and execute it with a 15-30 seconds delay. So the element will start heating 15-30
seconds after the surface element control was turned ON. The element control display will
not show the settings because "Sb" is always displayed. When necessary, it is possible to
adjust the power of the surface element but you have to remember that the surface
element control will adjust the temperature with the same delay. Note: The WARM feature
doesn't work during Sabbath mode.
To turn OFF the Surface Element when the Oven Sabbath Mode is active:
To shut OFF the surface element while the Sabbath feature is ON, proceed as usual but
take note that the element will immediately turn OFF without any delay.
To deactivate the Sabbath Feature Mode:
Touch and hold for few seconds simultaneously key of the Minute Timer Control and
lock
key. When the Sabbath mode is deactivated the unit turns OFF.
Note: If a power failure occurs during sabbath mode when the power comes up "SF" will
showed on the radiant element control displays and on the minute timer control displays
Fig. 2
(Fig. 2). On induction element control displays will show "-". All radiant elements will turn
OFF. The unit can be operated again as Sabbath mode.