Download  Print this page

Operating The Dual Surface Radiant Element - Electrolux EW30CC55G B Series Use & Care Manual

Radiant/induction electric cooktop
Hide thumbs

Advertisement

Table of Contents

OPERATING THE DUAL SURFACE RADIANT ELEMENT

Both the 30" and 36" cooktops are equipped with dual radiant surface element
located as shown in Figs. 1 & 2. A touch key pad on the element controls is
used to select one of the 2 positions of the element. Symbols and indicator
lights on the control panel are used to indicate which coil of the dual radiant
element will heat. The
symbol indicates that only the INNER coil will heat
(Fig. 3). The
symbol indicates that both INNER and OUTER coils will heat
(Fig. 4). You may switch from either coil setting at any time during cooking.
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
POWER
indicator light above the
is touched within 20 seconds the request to Power ON the cooktop
will clear.
3. Touch and hold the
ON OFF
is heard. Note: If no further pads are touched within 10 seconds the
request to power the element ON will clear.
4. Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by
touching the
key pad.
size
5. Touch
pad once to turn ON the power level to HI or touch
power level to Lo.
6. Each touch of the
the lowest power level available. Note: The power level may be adjusted at any
time while the element is ON.
7. Start most cooking operations on a higher setting and then turn to a lower setting to
finish cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.
8. When cooking has been completed touch the
and if no other surface element is used touch the
cooktop.Note: The Hot Element (HE) message will be showed on display for each
element until the heating surface area has cooled sufficiently.
CA
CA
UTION
UTION
CA
CA
CAUTION
UTION
UTION
!
Radiant surface elements may appear to have cooled after they have been turned OFF. The Hot
Element (HE) message will be showed and will continue to display until the glass cooktop has cooled
down to a moderate level. The glass surface may still be hot and burns may occur if the glass surface
is touched before the display has turned OFF.
Setting Surface Controls
key pad until a beep sounds. The power
will turn ON. Note: If no other key pad
POWER
pad for the dual element position until a beep
or
pad will increase or decrease the power level. Lo is
ON OFF
lock
warm
POWER
pad once for
pad once to turn the element OFF
key pad to turn off the
POWER
19
-
lo
hi
+
-
lo
hi
+
-
lo
hi
+
-
lo
hi
+
POWER
lock
warm
ON OFF
Fig. 1
-
lo
hi
+
-
lo
hi
+
-
lo
hi
+
-
lo
hi
+
-
lo
hi
+
ON OFF
ON OFF
ON OFF
ON OFF
ON OFF
timer
Fig. 2
Fig. 3
Fig. 4
timer

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux EW30CC55G B Series

This manual is also suitable for:

Ew36cc55g b series