Bosch GCO 2000 Professional Original Operating Instructions page 12

OBJ_BUCH-385-005.book Page 12 Friday, October 17, 2008 10:39 AM
12 | English
Maximum Workpiece Dimensions [mm]
Workpiece Form
120 x 120
180 x 85
140 x 140
1 609 929 S36 | (17.10.08)
Adjusting the Depth Stop
(see figure E)
Miter Angle
In the delivery condition of the machine, the
0° 45°
depth stop 4 is adjusted in such a manner that a
130 Ø 110 Ø new 355 mm cutting disc does not touch the
base plate when cutting.
To compensate the wear of the cutting disc, the
depth stop can be set deeper.
90 x 90 When using a new cutting disc, the depth stop
must then always be set back to the original po-
sition.
100 x 80
– Place the machine in the working position.
90 x 90
– Loosen the lock nut 5 with the box-end
– Swing the tool arm with the handle 1 to the
– Screw the depth stop 4 in clockwise or coun-
– Slowly guide the tool arm upward and tight-
Always adjust the depth stop in such a man-
ner that the cutting disc does not touch the
base plate when cutting.
(see "Releasing the Machine (Working Posi-
tion)", page 10)
wrench 8 (size 13 mm) provided.
requested position.
terclockwise direction until the screw head
touches the housing.
en the lock nut 5.
Bosch Power Tools