LifeSpan BOLT Owner's Manual page 13

4.3. Preset programs:
Press the program button; programs from P1 to P12 are built-in programs. The time window displays the
default value of TIME. When flashing, press the SPEED buttons to adjust to your desired time. Built-in
program are divided into 20 equal segments. After pressing the START button, the treadmill will
automatically cycle through the time segments. Speed will automatically adjust to the preset value for the
segment. Upon completion of the segments, the program will end, slowing the treadmill down to a stop.
During the operation speed can be adjusted but the next segment will be automatically adjusted to the
program defaults. Built-in program data is listed on the Program Chart at end of this section.
4.4. Heart Rate:
When holding the hand pulse with two hands, the pulse window will show your heart rate after 5 seconds.
To increase accuracy please check heart rate with the machine stopped and after keeping your hands on
the sensors for more than 30 seconds.
The heart rate data is for reference purposes only and should not be used for medical purposes. See
the end of this document for further detail.
4.5. Sleep function:
The treadmill automatically enters sleep mode after 10 minutes of inactivity. Press any key on the display to
wake the treadmill.
4.6. Data display and set range
0.8KMH—12KMH
Speed
Time
0.00KM—99.9KM
Distance
Calorie
BOLT
:
Show Range
0:00—99:59
0Kcl—999Kcl
Program
Mode Default
Default
-------- --------
30:00 30:00
1.00KM --------
50Kcl --------
13
Setting Range
--------
5:00---99:00
0.5KM—99.5KM
10Kcl—995Kcl