Table of Contents
Advertisement
10. TROUBLESHOOTING GUIDE
Before contacting your robot dealer, please read through this guide.
Problem
The robot is moving in circles or
does not reach all areas of the pool.
The robot is not moving sideways on
walls.
The robot does not climb walls.
Robot is not sinking.
Remote control unit is not working.
The robot stops working before
completing the cleaning cycle.
The "No connection" LEDs are lit
when charging.
The green light on the float remains
on after the robot has finished a
cleaning cycle.
When the on button on the float is
pressed the robot does not begin to
work and the red LED flashes.
Liberty Premium 8
Liberty_Premium_English.indd 17
Liberty_Premium_English.indd 17
Solution
1. Check that no foreign objects are blocking the moving parts.
2. Make sure the filter cartridge is clean and well-mounted and that
the filter doors are closed.
3. Before using the robot at the beginning of the season, brush any
algae from the floor and walls of the pool.
Adjust the diagonal angle of the handle.
1. Clean the filter cartridges.
2. If this is the beginning of the season, use the spring cartridge.
3. Check if brushes are worn and replace them if necessary.
4. Make sure the impeller area is clean.
5. Check that the remote control is set for climbing.
If using Wonder brushes or the combined brushes make sure they are
soaked in water.
Check if the batteries need to be replaced.
1. Check if the impeller is blocked.
2. Check if the drive system is blocked.
3. The battery may be empty; charge the robot.
If none of the above help, please contact your dealer.
Check that the charging cable is connected properly and that the
connectors are dry. Wait 10 seconds and try again.
The charging contacts on the float are wet. Dry the contacts before
charging.
The battery is empty. Recharge the battery.
User Instructions
|
17
4/2/12 6:19 PM
4/2/12 6:19 PM
Advertisement
Table of Contents
