Pot Detection For Flexinduction Models - Siemens EH675TK11E Repair Instruction

5.24

Pot detection for FlexInduction models

Warning!
If the pan is not detected correctly, it is necessary to verify the pan
situation respect to the NTC of the oval inductor.
The aesthethic help us to know where we must place the pots.
5.24.1 Pot detection
The recommendation to obtain a good pot regulation is as follows:
o For pot diameters minors of 130 mm ,we must place
them centered in the middle of the oval inductor. The
aesthethic help us to know where we must place the
pots.
o For pot diameters major of 130 mm, we must place them
between two oval zones, with both NTC covered.
If we don´t follow these recommendations, the pot can not be
detected in some ocasions
 when it is off-centered, it would not be detected for security
206_58300000141095_ara_en_k.doc – 04.10.a
5.24.2 Flexible zones aesthetics
5.24.2.1 For Bosch models
Seite 106 von 113