Checking The Lcd Touchcontrol - Siemens EH675TK11E Repair Instruction

5.22

Checking the LCD TouchControl

Attention!
Before replacing the TouchControl, observe the following steps:
5.22.1 Symptoms
 No function is available.
 The display shows more or fewer hotplates than the hob has.
 F0 is indicated on the display.
5.22.2 Cause
The coding of the TouchControl is not the correct one.
5.22.3 Troubleshooting
Recode the TouchControl via the coding programme of the LCD
variants.
The variant which is to be coded can be found on the rating plate.
V1 for example means variant 1.
See photo.
206_58300000141095_ara_en_k.doc – 04.10.a
5.22.3.1 Accessing the coding programme
 On all LCD models press the front right sensor.
 Press On/Off sensor without taking your finger off the hotplate
select activation.
 LCD display lights up.
 Take your finger off the hotplate select activation.
 LCD display remains lit.
 Press hotplate select sensor (without taking your finger off the
On/Off sensor).
 P0 is indicated.
 Access the variant coding by repeatedly pressing the On/Off
sensor. Programme "PV".
5.22.3.2 Variant coding
In the "PV" programme press the +/– button to select a variant which
corresponds with the rating plate. Save variant by pressing the On/Off
button.
Seite 102 von 113