Error No. List - KERN GAB 3K1DM Service Manual

3. EPROM clear
･ Any scene of F mode is possible.
3.1 Press the ZERO key and MODEkey. → "EP-C" then "C1-1"
is displayed.
At this point, writing in EPROM of change data in
F mode and the default value to EPROM clear
has not been completed. Push the memory
switch.
EPROM clear initializes Country No., Scale No.,
Zero, and Span adjustment values. It is
necessary to set it again.
4. Writing in EPROM
･ Push the memory switch to memorize data.
After EPROM is cleared, if writing is performed in
EPROM without setting Country No., Scale No.
nor Zero/Span adjustment value, and the power
is turned on, "Err1" is displayed and it is not
possible to use the machine. Set C1, C2, and C3
again.
Data after EPROM is cleared
Mode Data
C1 1
C2 11
C3
F 804

2.1.10 Error No. List

Error No. Mode
Err1 At power ON
Err2 At power ON
Err3 Test mode
Err4 Test mode
Err5 Test mode
Err6 Normal mode
JAPAN
Scale No.= 3kg (2g/1g) Multi interval
Zero point and span adjustment value and each approximate value
Measurement condition
EPROM unsetting or garbled data
Outside start range
Outside range where zero point can be adjusted (original A/D 1000
count or less)
(Original A/D 25000 count or more)
Outside span adjustment possible range (original A/D 33300 count
or more)
Original A/D zero count or less
- 14 - GAB/GAS-SH-e-0711
Item
Decimal point indication= " 0"
Item
↓