True Fitness ES900 Owner's Manual page 35

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 14 Power Cord Installation:
a) Insert Power Cord into Power Inlet receptacle of front electrical panel of treadmill. See Fig. 14-1 for location.
b) b. Install Spacer (k), Retainer - Power Cord (l), and screw (m) as shown in Fig. 14-1 but do not tighten.
c) c. Rotate power cord retainer down and tighten screw to push retainer up against Power Cord.
See Fig. 14-1.
POWER SWITCH: 1 = ON, 0 = OFF
CIRCUIT BREAKER: In the event the current drawn by the treadmill exceeds a specified threshold value, the Circuit
Breaker will operate; the button will pop out, and open the circuit. If this should occur, please wait 10 minutes and then
reset the Circuit Breaker by pressing the button in on Circuit Breaker. If it does not reset, or the Circuit Breaker operates
again, please contact True Fitness Service department at 1-800-883-8783.
CLOSED
CIRCUIT BREAKER POSITIONS
Circuit Breaker
RJ45
adapter
TV Cable Fixing Base
Fig. 14-1: ES900 Treadmill Front Electrical Panel
OPEN
Truefitness.com / 800.426.6570 / 636.272.7100
Power Switch
Power Inlet
31