True Fitness ES900 Owner's Manual page 30

CHAPTER 2: ASSEMBLY INSTRUCTIONS
Step 11 Decline Foot Assembly Installation & Leveling:
a) Position cardboard from packaging next to side of base unit.
b) Using 2 people, tilt treadmill on one side so that cardboard protects side of unit.
c) While one person holds treadmill securely in place, the other person must unscrew both rear leveling feet. Place to
side for later use. See Fig. 1.
d) Install two leveling feet on decline foot assembly, with leveling foot with extra jam nut to be placed on the shorter
post of decline foot assembly. See Fig 2.
e) Install Decline Foot Assembly onto existing foot mounts of treadmill frame. Align two grooves in Decline Foot
Assembly with two grooves in treadmill frame bottom. They should both be on the left side of the base unit.
Ensure that you leave approximately 1/4 inch gap between the jam nut and the base of the decline foot on the right
side of the pedestal. See Fig. 3.
f) Secure with four 1/4-20 x ¾ hex head bolts included in kit.
g) Using 2 people, carefully tilt treadmill upright.
h) Ensure treadmill incline rack wheels and rear feet are resting on the floor and not on cardboard,
packaging, etc.
i) Using a 15/16 inch open end wrench, loosen nut A on Right Rear Foot (only side adjustable). Fig. 12-2
j) Using a level or estimating by sight, turn section B of foot clockwise, or counter-clockwise, using a 7/8 inch open
end wrench to level the rear of treadmill.
k) Tighten nut A until it is secured against bottom of treadmill.
NOTE: The protective film covering the frame sides and front can be removed at this time.
Fig 1
Fig. 12-1
Truefitness.com / 800.426.6570 / 636.272.7100
Fig 2 Fig 3
Fig. 12-2
26