True Fitness ES900 Owner's Manual page 18

CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS (continued):
Step 3-1 Frame Cable Connections:
Fig 3-1-1
Connect Network
Cable Here
Washer
Nut
Fig 3-1-2
a) Route the cables exiting from Pedestal – R into cable restraints
and secure with two O-rings (d) as shown in Fig. 3-1-1 to the
left. Eliminate any slack in cables to ensure they are not
pinched when pedestals are upright.
b) Route the COAX Cable and Network Cable to the front of
c) Connect the network cable to the network jack on the power
d) Remove nut and washer from front of COAX Cable as
e) Pass front of COAX Cable through hole in electrical panel
Pass COAX Cable
Through Here
Truefitness.com / 800.426.6570 / 636.272.7100
the treadmill frame.
plate as shown in Fig 3-1-2
shown in figure 3-1-2
and install washer and tighten nut using 1/2 inch open end
wrench on nut and long nose pliers on connector portion of
cable.
NOTE: Torque specification for tightening all COAX
connections is 1.8 ft-lb
14